Apple Mouse Card PIA chip

6 posts / 0 new
Last post
Offline
Last seen: 1 week 1 day ago
Joined: Apr 26 2016 - 08:36
Posts: 745
Apple Mouse Card PIA chip

Hi guys.

 

I've got an Apple Mouse card with a dead PIA chip - the large 337-6521 that's labeled "6520" on the silkscreen.

Not easy to find replacements, but I wonder if it's compatible with the new prodiction WDC 65C21:

https://www.westerndesigncenter.com/wdc/w65c21-chip.php

 

Anyone have an opinion on this?  They seem to match pin-for-pin when I look here:

http://archive.6502.org/datasheets/rockwell_r6520_pia.pdf

and here:

https://www.westerndesigncenter.com/wdc/documentation/w65c21.pdf

 

CVT
CVT's picture
Offline
Last seen: 44 min 28 sec ago
Joined: Aug 9 2022 - 00:48
Posts: 1175
Looks like it is. It say at

Looks like it is. It says at the bottom:

 

Replacement for Motorola/Freescale / Rockwell / AMI / MOS Technology / MOSTEK / HITACHI / ST Microelectronics / GTE / CMD, 6520, 6521, 6820, 6821, PIA′s

 

and mine is AMI S6821P:

 

MacFly's picture
Offline
Last seen: 22 hours 22 min ago
Joined: Nov 7 2019 - 13:49
Posts: 484
Pins and functionality is

Pins and functionality is compatible - as the datasheet says. But the 6521 differs in electrical characteristics. It comes in two variants - "N" and "S". The "S" variant is able to drive much higher loads. If CVT's board used the 6821, then I would try the "N" variant if possible (since the 6521N is specifically meant as a drop-in replacement for the 6821). The "S" type will probably also work (but it has no current-limiting resistors at its output ports, so is able to drive higher loads but might be more easily damaged).

The 6521 can be clocked at up to 14 MHz. It will be pretty bored with Apple II's 1MHz bus... :) But it should work...

S.Elliott's picture
Offline
Last seen: 9 hours 14 min ago
Joined: Jun 23 2022 - 16:26
Posts: 247
Jameco has it in-stock

Moreover, Jameco has this 6521 PIA in stock at $12.95.

Their copy of the Rockwell R6521 datasheet explicitly says "Direct replacement for NMOS R6520 or MC6821 PIA."  But Jameco doesn't identify which brand they're selling, so their inventory might not be the Rockwell part.

Funny thing...I saved a couple of them from a defunct Commodore PET, and I'm really not sure why.  Back in the 80's these were easily obtainable in Jameco's distinctive yellow cardstock packages for about $4.  So why did I bother keeping these pull-outs of unknown quality?

Offline
Last seen: 15 hours 39 min ago
Joined: Apr 1 2020 - 16:46
Posts: 1007
A source for original NMOS 6520 (and family) for a good price !

You can buy 6520A for $1.95 each at Anchor Electronics in Santa Clara. All my Apple-1 kits used that source. These came out of Atari and never left the USA. They are marked with "6520A" and "CO14795-12" which is the Atari house marking. They were made in the early 1980s by either Synertek or Rockwell (specify when you order). Anchor also has lots of 6502B with the Atari house marking "CO14377" in stock, made by MOS Technology in the late 1970s. For $4.95 they are a steal.  Anchor also has most of the 74xx and 74LSxx used in the Apple-1 and Apple II at very good prices (the best prices I found anywhere).

www.anchor-electronics.com

 

- Uncle Bernie

 

Offline
Last seen: 2 hours 2 min ago
Joined: Jun 29 2018 - 16:55
Posts: 590
UncleBernie wrote:You can buy
UncleBernie wrote:

You can buy 6520A for $1.95 each at Anchor Electronics in Santa Clara. All my Apple-1 kits used that source. These came out of Atari and never left the USA. They are marked with "6520A" and "CO14795-12" which is the Atari house marking. They were made in the early 1980s by either Synertek or Rockwell (specify when you order). Anchor also has lots of 6502B with the Atari house marking "CO14377"

 

Very nice, I just ordered some PIA and SIO ICs from there. 

Log in or register to post comments