Apple II+ SN74194N vs 74LS194

7 posts / 0 new
Last post
Offline
Last seen: 7 months 1 week ago
Joined: Apr 29 2009 - 01:58
Posts: 73
Apple II+ SN74194N vs 74LS194

I have a broaken, right at the casing too close to solder, leg SN74194N and I do not have any extras. Can I use a 74LS194? I can get a few at a store about 1/2hr away for $2. Or the only sn74194s's I can find are expensive or come from europe and take weeks to get here. Or is there another option?

Thanks

Offline
Last seen: 9 hours 17 min ago
Joined: Jun 18 2010 - 13:54
Posts: 798
No guarantees, but an LS194

No guarantees, but an LS194 will probably work just fine. You could also try a 74HCT or 74ALS if that doesn't work.

Bad-Apple's picture
Offline
Last seen: 4 years 1 month ago
Joined: Nov 10 2019 - 10:30
Posts: 10
Should be OK.

Should be OK.

For Texas Instruments parts like this (the SN one)  this site is quite useful to look up equivalents: https://bomcross.ti.com/en/search?searchTerm=74LS194N&qty=1000

Datasheet from there which may be useful: http://www.ti.com/lit/ds/symlink/sn74ls194a.pdf

According to the Wikipedia article on the 7400 series ICs, the last letter in the naming convention is used differently by different manufacturers. https://en.wikipedia.org/wiki/7400-series_integrated_circuits

 

Hope that helps, would be interested to know the outcome.

 

 

 

 

Offline
Last seen: 2 weeks 2 days ago
Joined: Jun 5 2008 - 07:26
Posts: 478
I'm not 100% sure, but I

I'm not 100% sure, but I  think it's unusual that an Apple II plus has a 74194 on it - I think all the 74194 type parts are LS - check the silk screen.

 

regards,Mike Willegal

Offline
Last seen: 7 months 1 week ago
Joined: Apr 29 2009 - 01:58
Posts: 73
Thanks, I got a LS194.

Thanks, I got a LS194.

No change so far.

 In my little IC tester, it reports an 74LS51PC as a 74LS 20 or 74LS13.

Are all these the same of is only part of the 51 working that shows as a 20 or 13?

 

Offline
Last seen: 7 months 1 week ago
Joined: Apr 29 2009 - 01:58
Posts: 73
*fix type sentance above

*fix type sentance above

  If only part of the 51 working would that test as a 20 or 13?

 

Offline
Last seen: 9 hours 17 min ago
Joined: Jun 18 2010 - 13:54
Posts: 798
No, they are completely

No, they are completely different chips. The LS51 is a Dual 2-Wide 2-Input/ 2-Wide 3-Input AND-OR-INVERT Gate while the LS20 and LS13 are Dual 4-Input NAND Gates (the LS13 having Schmitt trigger inputs). The last two might check the same on your tester, but the LS51 should test completely different. It might also be your tester incorrectly identifying it.

Log in or register to post comments