PHILIPS 22UF 25V AXIAL CAPACITOR 4.5X10.5MM

From the pics on eBay. They don't look like the correct caps.

I don't recall the exact part number. It's not just size and manufacturer, but package and series you need. I think the last set I got was from a surplus place I went in person, but I had an original cap that was damaged from an Apple-1 with me to make sure it was the same.

There are modern ones that look pretty close and would be safer to use. I may have that part number also from an old mouser order. They aren't exact but they are close. I can look tomorrow.

Cheers,
Corey

Well, I made the mistake of purchasing this item thinking that they were correct for my Apple 1 replica. They were all bad, a few were open and the best were only about 10uf with very high ESR. They must be very old stock. Don't waste your money.

Dick Stachowiak
East Syracuse, NY

Those are widely available - if you just want a part of the correct value, fit and the approximate color:

Vishay part number:MAL202138229E3

http://www.digikey.com/product-search/en?pv7=2&k=4068PHCT-ND&mnonly=0&newproducts=0&ColumnSort=0&page=1&quantity=0&ptm=0&fid=0&pageSize=25

regards,
Mike W.

Hi dear friends, i find this:

http://www.ebay.it/itm/Lot-de-5-condensateurs-chimiques-axial-22uF-40V-NEUF-/141302424171?pt=FR_YO_MaisonJardin_Bricolage_ElectroniqueComposants&hash=item20e647e26b#ht_772wt_1161

Dimension and colour are best for good replica

Best regards from Italy

Giuliano

What are the correct dimensions for the original small blue 22uf caps?

len

I suppose someone might have the official Philips data sheet, but I measure them as approximately 11mm x 6mm

Thanks Mike,

I thought the 4.5mm looked a bit small in dia, but pretty close on the width.