I made some perforated prototype cards for a project, unfortunately the solder pads got covered by the protective layer, so I guess they are now wire-wrap boards. They can be exposed with some sandpaper. Also the edge connector is not long enough, the pins will make contact, but make sure they are all aligned. Asking $6 each and whatever shipping cost may be.
Images:
Proto card
Card in slot
Davey,
I would be interested in two(2).
Do you have a Paypal account?
Steven
PM sent...
Payment sent.
Thanks Again.
Cards arrived today! Cool!
Thanks Again.
Update: These have all been sold
If anyone still has interest in these I might be making another batch with corrections or possibly larger cards.
Ahh now maybe I could make a Disk III card with these half-size jobbers.
What would you charge for the Corrected Version, or the estimated cost of the Larger Version??
I'd do $5 per board on the corrected small boards.
I was doing some math for the large boards, the place I am getting these made has much higher costs for larger PCBs unless I buy a large quantity. If I do buy a large quantity and depending on size it may be about $7-$8. If I buy a small quantity, it would be about $12-$13 for large perf board.
Count me in for Qty=5 of the larger boards if you build them for under $10
Davey,
I'm in for five Large Boards up to $12.00 each.
If they turn out to be $10.00 each, thats good too.
Steven
I'm interested as well but curious about the design for the larger board.
The large board looks the same as the small one, just longer and a tad taller. I might add some voltage rails to the small one to see how those come out because I'm making a small quantity of those.
I would be interested is some of each.. when is tse expected avaliable of each card??
I would also be interested in some of each.
Just sent in the designs, might be about a week or two until I get them.
Pricing as follows:
$8 per Large board
$5 per Small board
$7 per Large board if you buy 4 or more.
Kewl... Let us know when they arrive. Thank you!
Just to provide an update for everyone. The service I am making the boards with has run into a few issues with shipping, may be another week or so. Will let you all know when the boards will be available.
The cards are in! I had been misinformed about the shipping time estimate...
Large card compared to old small card:
New small card (yellow) compared to old small card:
Cards in slots:
Height difference, Large and old small card.
Thicker traces:
Again, pricing as follows:
$8 per Large board
$5 per Small board
$7 per Large board if you buy 4 or more.
(Does not include shipping)
I'm in for 4 Large.
I'll make payment shortly and toss in $5.00 shipping.
Done!
I would love to purchase 2 of each, 2 large and 2 small please if they are available.
I'm trying to build a Uthernet card, I have reverse engineered the design with the original designer's blessing.
I need a prototype board to build it on.
How do i make payment?
BTW I am in Adelaide, South Australia
Thanks and Cheers, Martin...
5 large for me. Thank you!
Davy,
Is that your prototype board for sale on eBay?
Yes, those were. Let's try and not keep too much discussion on this thread as it is a FS thread...
Anyway, yes, I was sure there were some people in the non-AF community that could use these.
I still have a few Large and Small available.
Count me in for two of each size ^_^